LMER Fiber 12-Gallon Drum Specification
| Description | Stores
Catalog Number |
Packaging
Filling Instructions |
Plant |
| Drum, Fiber, open head, 12
gallon, 15 1/2 in. ID x 14 3/4 UN 1G/Y 75/S, 700 lb. sidewall, Natural Kraft |
02-113-5738 | LMTPM-CHK-38 | Y-12 |
Mfg. Details Per:
LMER Packaging Specifications
No. 200-1G0-0002
Issue Date: April 15, 1994
Revised Date: June 15, 1999
| The following inspections will be performed on the incoming drums by receiver to determine the drums meet quality standards and the requirements of this document. However, the receiver is not limited to the following inspections to determine quality and specification conformance. Conformance will be indicated by a Y or N in the "Y/N" column, and negative responses documented on the Nonconformance Report (NCR), UCN 11457, (items 3-21b), attached to the checklist, and submitted to Lockheed Martin Transportation and Packaging Management (LMTPM) for necessary action. |
This checklist is to be reproduced for QC Inspections.
Receiver Inspection Quality Control (QC) Checklist for Incoming Fiber Drums |
|||
QC Conformance |
Y/N |
<< "No's" to be documented on form UCN-11457, with checklist |
|
1 |
Drum condition | Drums in good physical condition; are dry, no physical damage. | |
2 |
Capacity | Drum is capacity specified in Order/Catalog Description (marked on drum side). | |
3 |
Fiberboard Surface | Clean, no significant scuffing, breaks or cuts in exterior surface, nor interior surface of the drum. Exterior has protective coating. | |
4 |
Locking rings, chimes | Lever locking rings, and metal chimes are painted or varnished and show no significant rusting /corrosion. | |
| Lever locking rings close tightly; not loose around drum lid. | |||
5 |
Drum lids | Lids are varnished, and show no significant rusting/corrosion. | |
6 |
Markings (on side) |
Drums marked (as a minimum) with LMER specified UN markings, per Catalog Description. | |
| Drums legibly marked (printed) in accordance with required 49 CFR UN markings, and specified gross test weight, below top chime. | |||
| CATN--plus the
last four (4) digits of catalog number, below UN markings per ¶ 5.0. |
|||
| Catalog Number___________________________ | P. O. Number________________________________ |
| Total Units Received_______________________ | Inspection Method: Per LMTPM QC Inspection Plan |
| Sample Size_______[Based on ANSI/ASQC Z1.4-1993] | NCR No._______________________ |
| Inspector/Date_________________________________ | Additional comments on back: _____check, if yes. |
| The above QC inspection check list shall be accomplished for each order based on random samples of incoming carbon steel drums, by LMER facilities to determine manufacturer's conformance to these specified LMER Packaging Specifications. |
| Shipments of carbon steel drums not meeting specified requirements will be returned to the seller for credit. |
| QC inspections resulting in non-compliance with these Packaging Specifications will be cause for rejection of the entire shipment. |
[TPM
Home] [ORNL Home] [Disclaimer]
[Website
Comments] [Contact
Us] |