The current fisheries research vessel the Albatross IV perpetuates an
illustrious name among research vessels starting with the steamer
Albatross of the United States Commission of Fish and Fisheries. In the
year 1881, at the suggestion of Commissioner Spencer Fullerton Baird,
Congress authorized an appropriation totaling $148,000 for the
construction of the vessel. Plans were drawn by Charles W. Copeland of
New York and a contract for construction was awarded to Pusey & Jones
of Wilmington, Delaware. The keel was laid in March 1882, the ship was
launched in August, and she made her trial run on December 30.
Thus began the long career of the United States Fish Commission
steamer Albatross, the first vessel built especially for marine
research by any government. During her forty years of service she
surveyed the Newfoundland Banks, the Bering Sea, visited scattered
archipelagoes of the Pacific, and served in two wars." (Hedgpeth, 1945,
American Neptune, vol. 5).
The Albatross was an iron twin-screw vessel propelled by two
independent two-cylinder steam engines designed by Mr. Copeland and
built by Pusey and Jones. Each engine developed about 200 net shaft
horsepower delivered independently to each of the screws which were
nine feet in diameter and constructed of cast iron. Steam was generated
by two coal-stoked boilers which were placed fore and aft in the hold
of the vessel. The vessel had a cruising speed of somewhat under 10
knots and consumed a little over 100 pounds of coal per mile at this
speed.
The Albatross was also rigged as a brigantine and carried the following
sails: mainsail, gaff-topsail, foresail, fore trysail, foretop-sail,
foretop-gallant sail, fore staysail, jib, and flying jib. Her total
sail area was 7,521 square feet.
Her hull statistics were as follows:
Length over all 234'
Length at 12-foot water line 200'
Breadth of beam, moulded 27'6"
Depth from top of floor to top of deck beams 16'9"
Sheer forward 3 '
Height of deck-house amidships 7 '3 "
Displacement on 12-foot water line 1074 tons
Registered tonnage (net) 384 tons
The vessel was provided throughout with electric lights--it is said
that it was the first government vessel to be so equipped. The dynamo
was designed by Mr. Edison who selected a particularly fine steam
engine manufactured by Armington & Sims of Providence, Rhode Island, to
drive it. The dynamo generated 51 volts and a current for 120 lamps.
Edison electric lamps also were used for underwater observation of
marine organisms at night and for attracting fish and other animals to
night light stations. The deep-sea cable used for the light was 940
feet long.
The vessel was especially designed for dredging and the collection of
bottom samples and animals at all depths. She had two well equipped
large laboratories for the preservation and study of biological
materials and the chemical analyses of water samples. One laboratory on
the main deck was 14 feet long and occupied the entire width of the
deck house. Another laboratory on the deck below was 20 feet long and
equipped with a photographic darkroom and a chemical laboratory.
The Albatross carried five boats: a Herreshoff Steam Cutter, a steam
gig, a seine boat, a whale boat, and a dinghy. The 26-foot cutter
seated eight people, was powered with a 16-horse-power steam engine,
and could make eigth knots, but it was also provided with sliding
gunter masts and sails, schooner rigged. Her bunkers held 1000 pounds
of coal.
The steam gig was 25 feet long, powered with 7-1/2 horse power engine
and was generally lighter than the cutter. It had a speed of seven
knots and seated seven persons. A peculiar feature of the boat was the
location of the propeller under the bottom, about half the length from
the stern. This prevented racing in heavy seas and made her performance
in a sea-way remarkable.
The seine boat was designed especially for mackerel seining. It was 38
feet long, pulled eight oars, and was schooner rigged with sliding
gunter masts. The whale boat was 26 feet long, pulled six oars, and was
also schooner rigged with gunter masts. The dinghy was 18 feet long,
pulled three pairs of sculls, and was rigged with a split lug sail.
Since the Albatross was especially designed for deep-sea dredging, the
dredging equipment was one of her most interesting features. She
carried 4,500 fathoms of 3/8-inch galvanized wire rope. The main
dredging winch was on the main deck, but the wire was stored on a reel
on the deck below. The wire rope from the dredge passed over the
dredging block at the end of the dredging boom, then under a sheave in
the heel of the boom, then upward and over a block suspended from a
special rubber accumulator, and then to the central gypsy head of the
main dredging winch.
After leaving the dredging winch the wire was passed below deck and
lead under a governor, then to a leading block forward of the storage
w'inch, and finally back to the reel of this winch. Through the action
of the governor, uniform tension was maintained on the rope,
compensating for the surging on the dredging winch. A level wind
distributed the rope evenly on the storage reel.
Deep soundings were made with a Sigsbee Sounding Machine powered by a
Bacon one-cylinder steam engine. It could reel in the sounding wire at
the rate of 100 fathoms per minute. A Tanner sounding machine was used
in depths of less than 200 fathoms and for navigational purposes.
Subsurface samples of water were collected with a Sigsbee water bottle
(then called a water-specimen cup) and an improved bottle invented by
Kidder, Flint, and Tanner. Temperatures were taken with Negretti and
Zambra deep-sea thermometers. Sea water densities were measured by
Helgard's ocean salinometer.
The Albatross was built as a result of discoveries made by the Fish
Commission vessel Flsh Hawk in New England waters and the first five
years of the Albatross' investigations were confined to the waters of
the Atlantic Shelf from Cape Hatteras to Newfoundland. After the trial
runs in the winter of 1882-83 she made her first scientific cruise in
the summer of 1883 from April to November, running from Washington to
Woods Hole and return, but investigating the fishes and bottom in a
wide area of the coastal shelf and Gulf Stream. On this cruise she
began amassing what was destined to become one of the greatest
collections of marine organisms ever made by a single vessel.
Innumerable publications have appeared based on the collections of this
pioneer vessel.
From 1884 to 1887 she continued work in the Northwest Atlantic and in
the Caribbean, making intensive dredging surveys and hydrographic
stations. In March 1887 she was sent to the Pacific to investigate the
fisheries of Alaska. She worked in these waters for three years
investigating the fishery resources and fishing grounds of the
Northeastern Pacific and Bering Sea, and in conducting hydrographic
work. She was assigned particularly to the study of salmon, the
Pribilof Islands' seal herds, and halibut.
In 1891 the Albatross made a special expedition to the tropical Pacific
off the west coast of Mexico, Central America, and the Galapagos
Islands under the direction of Alexander Agassiz of Harvard University.
Many of the collections of this and later cruises under Professor
Agassiz's direction were deposited in the Museum of Comparative Zoology
of Harvard University.
That same winter she surveyed the ocean bottom between San Francisco
and Hawaii to determine the best route for a submarine telegraph cable
to the Islands. For the next several years she was occupied with
Alaskan fishery investigations including continued study of the
Pribilof Islands' fur seals, studying their pelagic life as well as the
rookeries on the islands. She even became involved in enforcement work
after the fur seals came under international regulations.
Interspersed with the Alaskan duties were numerous biological surveys
conducted in various areas of the west coast of the Americas: a survey
of San Diego Bay in 1894, Puget Sound salmon fisheries in 1896-97,
halibut surveys, and a systematic survey of all salmon streams in
1897.
In 1898, during the war with Spain, she was detailed to the Navy. Her
dredging and collecting equipment was stored in Mare Island Navy Yard
and alterations made to her deck house And bunkers
The second Agassiz-Albatross expedition was conducted in 1899-1900.
During this cruise the Albatross made collections over a wide area of
the South Seas and Japan, adding enormously to our knowledge of the
flora and fauna of the Pacific.
In the period 1900-04, surveys were made along the West Coast, in
Hawaii, and Mexico under the direction of a number of scientists from
Stanford University and the University of California, including David
Starr Jordan, Barton Warren Evermann, Walter K. Fisher, Harold Heath,
and C. A. Kofoid.
The third Agassiz expedition (1904-05) took a number of scientists down
the west coast of South America to Galapagos, Easter, and Gambier
Islands.
"The 1906 cruise of the United States Fisheries steamer Albatross had for its
especial object the investigation of the fish and fisheries of the Japanese
seas, where the ship spent most of the time. The journey out was made by way
of the Aleutian Islands, at several of which we stopped, Petropaulski,
Kamchatka, and the Kuril islands. We returned by way of Honolulu. As the
purpose of the expedition was the investigation of fish and marine
invertebrates, and the ship was usually occupied in work offshore, my
opportunities for collecting birds were reather limited, especially as my time
was largely taken up by my duties in connection with the marine work, as the
representative of the Bureau of Fisheries."
In 1907 - 10 the Albatross made her famous Philippine expedition which
resulted in a wealth of information on the fishery and aquatic
resources of these fascinating islands. This expedition was under the
personal direction of Hugh M. Smith, Deputy Commissioner of Fisheries.
F.M. Chamberlain was naturalist on board. Others in the scientific
party included such well known biologists as H.C. Fasset, Lewis L.
Radcliffe, Paul Bartch, Albert L. Barrows, Alvin Seale, and Roy Chapman
Andrews.
After this great expedition the vessel returned to Alaskan studies and
surveys of the West Coast. During the years 1912-14 she made an
intensive survey of San Francisco Bay which resulted in a classical
monograph of the area.
From then until the First World War she continued dredging and
hydrographic surveys along the West Coast. During the war years,
1917-19, she was placed under control of the Navy and transferred from
the West Coast to Guantanamo, Cuba, for patrol duty in the Caribbean
and Gulf of Mexico.
After the war she returned to research in the North Atlantic, having
been away for over 30 years. In 1919 she worked in the Gulf of Mexico
in the environs of Cuba and off the South Atlantic coast. W.W. Welch
was in charge with E.P. Rankin as ship's naturalist. In 1920 she
surveyed the Gulf of Maine under the direction of Henry B. Bigelow,
conducting hydrographic and biological investigations. This was the
last scientific trip. In 1921 she returned to Woods Hole, the center of
the Commission's research in the North Atlantic, where she was
decommissioned on October 29.
The vast collections in the museums of this country, and the library of
scientific papers that resulted from her cruises substantiate the fame
this vessel acquired in all scientific circles of the world.
Home
Images of Albatross from www.photolib.noaa.gov
berthdeck.jpg
bow.jpg
bowphoto.jpg
cabin.jpg
chartroom.jpg
dredge-engine.jpg
dredging.jpg
lineart.jpg
lowerlab.jpg
lowerlab2.jpg
nets.jpg
photo.jpg
photo2.jpg
photo3.jpg
reeling-engine.jpg
steerage.jpg
stern.jpg
sternphoto.jpg
tanner-sounding.jpg
the-bird.jpg
upperlab.jpg
wardroom.jpg
wheelhouse.jpg
sigsbee-sounding.jpg