www.OSHA.gov | |
Standard Interpretations
01/31/1991 - Back-welding of threaded connections in anhydrous ammonia service. |
Standard Interpretations - Table of Contents |
Standard Number: | 1910.111; 1910.111(b)(7)(iv) |
January 31, 1991
Mr. Robert Brenton Director, Dear Mr. Brenton: This is in response to your letter of December 7, 1990, which pertained to back-welding of threaded connections in anhydrous ammonia service in compliance with the latest American National Standards Institute (ANSI) standard, published in 1989. We apologize for the delay in our response. In your letter, your question reads: "If we have seal welded threaded connections in compliance with the ANSI K61.1-1989 (and referenced ASME codes), are we in compliance with 29 CFR 1910.111?" As indicated in your letter, the applicable Occupational Safety and Health Administration (OSHA) standard for back-welding of non-refrigerated anhydrous ammonia system piping is at 29 CFR 1910.111(b)(7)(iv), which in part states: "Threaded connections shall not be back-welded." OSHA referenced the ANSI K61.1-1966, Storage and Handling of Anhydrous Ammonia, in the development of the its standards at 1910.111. The referenced ANSI standard (1966 edition) did not allow back-welding on the threaded connections, but the current ANSI standard (1989 edition), section 5.6.3 of ANSI K61.1-1989, allows back-welding on threaded connections. Under OSHA's de minimis violations policy, copy enclosed, OSHA recognizes an employer to be in compliance with the Occupational Safety and Health Act (OSH Act), if that employer complies with the requirements of the most current applicable industry consensus standards (such as ANSI K61.1-1989), which provide equal or greater protection to employees who may be exposed to hazards. Therefore, under this policy, back-welding of threaded connections in compliance with the ANSI K61.1-1989 for anhydrous ammonia systems is acceptable to OSHA, if all other requirements specified in the ANSI K61.1-1989 are met. OSHA will accept back-welding on the threaded pipes, only if the pipes are of schedule 80, and the fittings on these pipes are not made of cast iron. If we may be of further assistance, please contact us. Thank you for your interest in safety and health.
Sincerely,
Enclosure
Occupational Safety & Health Admin. RE: Back-welding of threaded connections in anhydrous ammonia service Dear Mr. Kanth: To recap our phone conversation of November 20, 1990: * 29 CFR 1910.111(b)(7)(iv), which address non-refrigerated ammonia piping, states in part: "Threaded connections shall not be back-welded." * ANSI K61.1 - 1989 addresses piping practices in 5.6.3 and specifies conformance to ASME B31.3 for non-refrigerated piping and ASME B31.5 for refrigerated piping. ASME 31.3(328.5.3) and 31.5(537.4.5) specifically permit seal welding of threaded connections. Question: If we have seal welded threaded connections in compliance with ANSI K61.1 - 1989 (and the referenced ASME codes), are we in compliance with 29 CFR 1910.111?
Sincerely,
|
Standard Interpretations - Table of Contents |
Back to Top | www.osha.gov | www.dol.gov |
Contact Us | Freedom of Information Act | Customer Survey Privacy and Security Statement | Disclaimers |
||
Occupational Safety & Health Administrations 200 Constitution Avenue, NW Washington, DC 20210 |