2/28/2000
					Steve Blusk

Hi all,					

  CM Lei and I discussed a couple of changes to the junction
card support structure.

1. Add a 1/8" space on the underside of the card to allow
for any nylon bolts which may be needed for strain-relief
of the cables. (also any residual solder near the connector
posts)

2. The outermost support disk will be moved inward to
1.5" inboard
from the edge of the larger card. This is because the highest
profile of the junction card will be at the Sense connector,
which is near to the edge of the card. Three low voltage
cables have to also pass over this connector, and so this
region consumes alot of radial space. By moving the support
in, this region does not have to "clear" the opening in
the support structure.

3. Reduction of mass?? Can we reduce the disks to 1/8"?

CM is going to add changes 1-2 and redo the layout. We then
should move quickly to a full-size prototype. What about
Item#3. I say we try to goto 1/8"....

Comments?


Thanks
Steve