------------------------------------------------------------------------
            Minutes - ICD meeting tuesday 17-NOV-1998 2 pm
                   at UTA with FNAL (EG,LS) by phone
                Send comments/corrections to Elizabeth
-------------------------------------------------------------------------
next meeting tuesday 24-nov-1998 at 2pm
-------------------------------------------------------------------------
# Lee is at Fermilab with 6 channels in a drawer with run II preamps.
# Elizabeth and Lee have met with various people including Lynn about
preamps and Pierrick about fiber polishing.

# MARK is putting together the driver board for the LED.
He will send 2 drivers to fnal, 
one which uses the TTL pulse with DC offset
one without DC offset (in case we don't have the right kind of pulser).

# Andy reports that Bicron agreed to put a clear film on the scintillator 
to protect it.

# Mark will send PMTs, stoppers, cookies to Fermilab:
 1.  6 working PMTs
 2.  96 neoprene stoppers
 3.  6 to 12 cookies 
If it's not done already, the cookies will be drilled with 2 holes 
    - hole for the fiber from Mark's LED block and 
    - hole to accommodate  one 2.2 mm fiber (its  a 1.0mm HP clear fiber
      with a black casing).

# Mark has sent PMT cup, holder hardware to LT:
 1) A PMT "cup" - the holder that mounts to the front of the drawer. LT
    needs one more.
 2) PMT holder hardware : We need some more of the screws that mount the
    cup to the drawer face, the screws that mount the sockets in the
    cup, the sleeves that slip over these screws and the springs that
    fit over the sleeves. We need enough for 12-14 channels. 
    In the absence of parts, send catalog numbers to Craig Neermann 
    (neermann@phys.latech.edu) so they can order them.
-------------------------------------------------------------------------