UNITED STATES
DEPARTMENT OF LABOR
MINE SAFETY AND HEALTH ADMINISTRATION
District 2
ACCIDENT INVESTIGATION REPORT
SURFACE COAL MINE
FATAL POWERED HAULAGE ACCIDENT
Kunkle Strip
(I.D. No. 36 08335)
Marquise Mining Corporation
Avonmore, Armstrong County, Pennsylvania
March 13, 1995
by
Joseph R. O'Donnell, Jr.
Coal Mine Safety and Health Inspector
and
Thomas G. Todd
Mining Engineer
Originating Office-Mine Safety and Health Administration
RR 1, Box 736, Hunker, Pennsylvania 15639
Joseph J. Garcia, District Manager
GENERAL INFORMATION
The Kunkle Strip is operated by Marquise Mining Corporation. The
mine is located approximately one and one-quarter miles from the
intersection of Route 156 and Allshouse Road in Avonmore,
Armstrong County, Pennsylvania. The mine consists of a single
operating open pit, extracting coal from the Double Freeport
seam, which averages 84 inches in thickness. Employment is
provided for 11 surface workers on one 10-hour production shift,
5-6 days per week with an average of 545 tons of coal mined
daily. Explosives, dozers, drills, front-end loaders and rock
trucks are used during mining operations. Haulage trucks
transport the coal to a nearby preparation plant operated by
Canterbury Coal Company.
The principal officers of the operation are as follows:
John M. Lee . . . . . . . . . . . . . . President
Claudia B. Lee . . . . . . . . . . . . Secretary
M. Weleski . . . . . . . . . . . . . . .Treasurer
The last Mine Safety and Health Administration regular Safety and
Health Inspection, at this mine, was completed August 23, 1994.
DESCRIPTION OF ACCIDENT
On Monday, March 13, 1995, the crew arrived at the No. 1 pit
office area for the start of the 6:00 a.m. shift. Kevin
Buszinski, Job Foreman, issued work assignments for the day.
Raymond Overly, rock truck driver, was assigned to haul mud from
the access roads and parking area to the spoil pile using a
Caterpillar, Model 773, 50-ton rock truck. Overly then began
hauling material to the west side of the spoil pile. He hauled
five loads from the lower mine access road, before moving to the
parking area. Three 85-ton rock trucks were operating out of the
pit area, hauling overburden and dumping on the south side of the
spoil pile. James K. Etling, dozer operator, noticed a soft area
on the south edge of the spoil pile. He then communicated, by
CB radio, to the rock truck operators instructing them to dump
short, due to this soft area. Etling informed them he would
later push the piles over the spoil bank with the dozer. Etling
then left the area to clean haul roads. Overly dumped two loads,
from the parking area, on the west side of the spoil pile, while
the 85-ton trucks dumped on both the west and south perimeters of
the spoil pile.
At about 7:30 a.m., Overly hauled his third load, from the
parking area, to the top of the spoil pile. He changed his dump
location to the south side of the spoil pile. While backing to
dump, he inadvertently traveled over the embankment. Vince
Ochiuto, rock truck driver, was preparing to back down to the
lower pit area, when he observed the 50-ton rock truck traveling
over the edge of the embankment. Ochiuto stated that the truck
began to roll on it's side and rolled several times before
reaching a bench area. When the truck struck the bench, it began
flipping end-over-end until it reached the bottom of the
embankment. Somewhere, near the bottom of the embankment, the
victim was thrown from the vehicle to the haul road.
John St. Clair, rock truck driver, was parked on the empty haul
road, facing east, when he heard rocks rolling down the
embankment. Turning left, he saw the 50-ton rock truck come to
rest on it's side with the cab facing west and the back tires
nine inches from the operator's cab of his truck. St. Clair
immediately called, on the CB radio, to Buszinski that an
accident had occurred and help was needed. Ochiuto and St. Clair
immediately exited their trucks and attempted to locate Overly.
Upon finding the victim, they observed the extensive nature of
the injuries and no apparent signs of life. First aid or cardio
pulmonary resuscitation (CPR) could not be administered.
Upon arriving on mine property at approximately 7:30 a.m., John
Lee, President, was told by Buszinski that an accident had
occurred, and an ambulance was needed. Lee went to the mine
office and notified security at the main gate to get an
ambulance. The guard then called Avonmore Lifesavers Ambulance
Service which received the call at 7:46 a.m. and arrived on the
scene at 8:05 a.m. Robert Bower, Armstrong County Coroner, was
notified and arrived at the scene at 9:20 a.m. The victim was
pronounced dead at 9:30 a.m. The body was transported to St.
Francis Health Center, Pittsburgh, Pennsylvania for an autopsy.
The cause of death was given as blunt force trauma with crushing
injuries.
MSHA was notified of the accident at 7:50 a.m. on March 13, 1995.
PHYSICAL FACTORS INVOLVED
The investigation revealed the following factors relevant to the
occurrence of the accident:
- Three Caterpillar, Model 777, 85-ton rock trucks were
being used to haul overburden from the pit to the spoil pile.
All trucks normally dump over the edge of the spoil pile unless
conditions dictate otherwise.
- A Caterpillar, Model 773, 50-ton rock truck was being used
to transport mud from cleanup activities along the access roads
and parking area.
- The weather on Monday March 13, 1995 was clear and dry. At
7:30 a.m., the sun was rising to the right of the truck, as
Overly backed to the south rim of the spoil pile. The
possibility exists that Overly's vision could have been impaired,
by the sun, in the right mirror as he was backing to dump.
- The top of the spoil pile was relatively level with dry
compacted material.
- An examination of the pit area only was made by Kevin
Buszinski, prior to commencing work and no hazards were found.
- A soft open area existed on the south edge of the spoil
pile, where no overburden had been deposited. This was at the
point where the overtravel occurred. The open area measured
approximately 18-feet wide. Sufficient overburden had been
deposited on the remaining perimeter, of the spoil pile, to
prevent overtravel.
- The rim of the spoil was not totally uniform. At the area
the vehicle was backing, the right rear tires were on solid
ground, while the left rear tires were over the embankment for
the last 18-inches at the open area. Normal tire tracks were
observed to the edge of the spoil pile (see sketch). There was
no evidence of skidding or braking before overtravel began.
However, there was approximately 3 feet of smooth tire tracks
visible, for the left rear tires, at the top of the downslope.
It appears the operator may have attempted to either brake or
pull forward once the truck began to go over the embankment.
- The gear shift was found in forward position, second gear
after the accident.
- The distance from the top of the spoil pile to bench was 90
feet, and the total distance from the top to the empty haul road
was 190 feet. The angle of repose of the spoil pile was 35
degrees in accordance within the approved ground control plan.
- All rock trucks were equipped with CB radios for
communication between miners throughout the entire mine property.
A verbal warning, by CB radio, was given by Etling, Dozer
Operator, to all rock truck drivers, that a soft area existed and
to dump short on the top and not over the edge of the south rim
of the spoil pile. All truck drivers interviewed acknowledged
hearing Etling's verbal warning and were aware of this condition.
- Overly had a hearing loss, which required the use of a
hearing aid. Overly may not have heard the warning, by Etling,
to dump short on the south perimeter of the spoil pile.
- The dump bed was not in the raised position when the
overtravel occurred.
- The Caterpillar 773 Rock Truck is equipped with four
braking systems. These systems are the service, parking,
retarder, and emergency secondary brakes. When the service or
emergency brakes are activated, both the front and rear brakes
are engaged. There are separate hydraulic circuits for the front
and rear brakes. The brakes are actuated by air over hydraulic
systems utilizing rotochamber and corresponding brake cylinder.
The front axle brakes are a shoe type with expanding hydraulic
bladders. The rear brakes are internal wet disc type. Both
front and rear axle brakes are applied by the hydraulic pressure
created in the brake cylinders when air pressure is introduced
into the rotochamber. This air pressure causes the rotochamber
pushrods to push against the brake cylinder pistons. The front
brakes can be manually deactivated, by a switch located in the
cab. Activation of this switch eliminates front wheel braking.
It is only to be used during adverse weather conditions.
- The retarder, parking, and emergency brakes were found,
after the accident, in the off or neutral position.
- The victim tested the rear axle service brakes on the
50-ton truck before leaving the parking area. The test was
witnessed by two other miners, and the service brakes stopped and
held the empty vehicle. According to the witnesses, no tests of
the other braking systems were observed.
- On March 15, 1995, the truck was turned upright, and
functional drawbar pull tests were conducted of the braking
systems. The results were as follows:
- The front brakes were completely inoperative. A slight
hydraulic leak was found in the left front bladder. Due to this
leak, there was not enough hydraulic fluid, in the front brakes
reservoir, to allow the front brakes to engage. The hydraulic
reservoir tank, for the front brakes, was nearly empty, and
evidence indicated the condition existed prior to the accident
occurring. The front brakes manual deactivation switch was found
manually deactivated in the operator's cab.
- The parking brake is a driveline spring applied and air
released brake. The parking brake was found to be out of
adjustment and inoperative.
- The retarder was operable. The emergency brake and
service brake were operable on the rear tires only. These three
braking systems are actuated by separate controls but they
actuate the same internal wet disc brakes on the rear axle.
- The air system plumbing for the brakes was intact and
functioning properly. It was necessary to replace one brake
fitting, obviously damaged in the accident, in order to conduct
tests. The air compressor could not be evaluated for pressure
ability or recovery rate due to the extensive damage of the truck
engine area.
- Although the front brakes were inoperable, all rear axle
brakes were capable of operating and sufficient to stop and hold
the loaded rock truck on grades at or above 25 percent.
- All tires were in good condition, with at least two inches
of tread. The right front tire had apparently deflated during
the impact, of the truck, during the accident.
- Drugs and drug paraphernalia were found by Armstrong
County Coroner, Robert T. Bower, in the victim's pockets at the
scene. The substance was confirmed to be Marijuana by the
Attorney General's Drug Task Force, Zelienople Base, Butler
County, Pennsylvania. An autopsy was conducted by the Allegheny
County Coroner's Office, the results of the toxicology study
revealed that cannabis was found in Overly's body. Because of the
residual characteristic of cannabis, it could not be determined
if this was a contributing factor.
- The victim was not wearing the seat belt, which was
provided in the rock truck. The seat belt was found intact, in
the truck cab, and in working condition. The belt was not
buckled and no signs of damage could be found. Rollover
protection was not provided nor is it required for the
Caterpillar 773 Rock Truck by 30 CFR 77.403a(a).
CONCLUSION
The accident occurred when for an unknown reason the Caterpillar
773 Rock Truck overtraveled the south edge of the spoil pile.
The driver was thrown from the vehicle, near the bottom of the
embankment, and struck by the rolling rock truck before it came
to rest. This resulted in his death due to blunt force trauma
with crushing injuries.
A contributing factor was that a means to prevent overtravel was
not provided for a distance of 18 feet on the south side of the
spoil pile. The perimeter of the spoil, at the accident
location, was not uniform resulting in the right rear tires being
on solid ground and the left rear tires over the embankment.
VIOLATIONS
- A 103(k) Order was issued to ensure the safety of miners
until an investigation could be conducted.
- A berm or similar means was not provided to prevent
overtravel at the rock truck dump area, a violation of 30 CFR,
Section 77-1605(l).
- The parking brake and front brakes, of the Caterpillar
773, were inoperative, a violation of 30 CFR, Section 77.1605(b).
- An adequate inspection was not conducted, on the
Caterpillar 773, before the rock truck was placed in service, a
violation of 30 CFR, Section 77.1606(a). All braking systems
were not tested, for proper operation, prior to use.
Respectfully submitted by:
Joseph R. O'Donnell, Jr. and Thomas G. Todd
Coal Mine Safety and Health Inspectors
Approved by:
Joseph J. Garcia
District Manager
Related Fatal Alert Bulletin: FAB95C04
|