HOW TO TAKE Test Pulse Timing Scan Data
(TOF GTM stand alone mode)
5/12/2001 by T.Chujo
0) login "phoncs0" from "phoncs"
account
and execute "setuponcs"
1) Initialize Timing module and FEM
> feed.pl &
Fig1. feed.pl display (initial)
Fig 2. feed.pl display after clicking "TOF"
-> click TOF
1. init timing
2. glinkreset
3. init fem
N
4. init fem
S
arcnet_client: configuration file:
"/export/software/oncs/online_configuration/Arcnet/tof/acf/tof_timing.acf"
"/export/software/oncs/online_configuration/Arcnet/tof/acf/tof_initN.acf"
"/export/software/oncs/online_configuration/Arcnet/tof/acf/tof_initS.acf"
[Message]
arcnet_client: Total number of errors: 0 from 6 files
arcnet_client: Total number of errors: 0 from 28 files
arcnet_client: Total number of errors: 0 from 28 files
2) GTM setting
> gtm GTM.TOF.E
Fig3. GTM.TOF.E display
-> click "File" and select "Load Mode Bits"
-> select "GTM.TOF.TPFA.gtm" and click "Open"
-> click "Schedular Reset" and see Level 1 counters are
"00000000"
both "Level 1" and "Level1 Busy"
-> click "Toggle Level 1 Block State" and make yellow signal
-> click "Toggle Local Forced Accept State" and make yellow
signal
3) DCM setting
> dcm tof.e
> 301 Read Configuration File
> 302 Show Current Configuration
> 303 Initialize Current Configuration
> 25 Check Ready State
-------------------------------
DCM control command
-------------------------------
(301) Read Configuration File
(302) Show Current Configuration
(303) Initialize Current Configuration
(25) Check Ready State
(305) Start Run for Current Configuration
(306) Stop Run for Current Configuration
(96) Initialize DD
(97) End DD
(98) Change Frame Size for SEB Test
(99) Change Send Delay for SEB Test
(307) Turn off all busies for Current Configuration
(308) Set the GL1 Partition Id
(309) Print the DCM Monitor Info
(310) Verify On-Board Memory (eg. Ped)
(311) Verify Level-1 Input Path
(312) Change Readout Method
(700) Configure to talk to another DCM
(800) Switch to Master-DCM Expert Mode
(900) Exit task
-------------------------------
4) Run time scan script
in GTM window, click "START"
> cd /export/bigdisk/tof/script_tscan/
> tof_tscan.tofgtm <run#> | tee ./log/xxxx.log
* ts command for boot
> ts iocondev4a
(auto boot) Ctr+x
(exit) Crt+]
(quit) telnet> quit
or close
* ddump command
> ddump -n0 -i -p (packetid) -f <file> | more