Test IKEv2.EN.R.1.1.8.2: INVALID_SYNTAX Part A: (BASIC)
To verify an IKEv2 device properly handles IKE message with an invalid syntax.
* [RFC 4306] - Sections 3.10.1
* Network Topology Connect the devices according to the Common Topology. * Configuration In each part, configure the devices according to the Common Configuration. * Pre-Sequence and Cleanup Sequence IKEv2 on the NUT is disabled after each part.
NUT TN1 (End-Node) (End-Node) | | |<-------------------| IKE_SA_INIT request (HDR, SAi1, KEi, Ni) | | (Packet #1) |------------------->| IKE_SA_INIT Response (HDR, SAr2, KEr, Nr) | | (Judgement #1) | | |<-------------------| IKE_AUTH request (HDR, SK {IDi, AUTH, N+, SAi2, TSi, TSr}) | | (Packet #2) |------------------->| IKE_AUTH REsponse (HDR, SK {IDr, AUTH, N+, SAr2, TSi, TSr}) | | (Judgement #2) | | |<-------------------| CREATE_CHILD_SA request (HDR, SK {N, N+, SA, Ni, KEi, TSi, TSr}) | | (Packet #3) |---------X | CREATE_CHILD_SA response (HDR, SK {N+, SA, Nr, KEr, TSi, TSr}) | | or |------------------->| CREATE_CHILD_SA response (HDR, SK { N(INVALID_SYNTAX) }) | | (Judgement #3) | | V V
N: REKEY_SA N+: USE_TRANSPORT_MODE
Packet #1 See Common Packet #1 Packet #2 See Common Packet #3 Packet #3 See below
* Packet #3: CREATE_CHILD_SA request (Part A)
IPv6 Header Same as the Common Packet #13 UDP Header Same as the Common Packet #13 IKEv2 Header Same as the Common Packet #13 E Payloa Same as the Common Packet #13 N Payload Same as the Common Packet #13 N Payload Same as the Common Packet #13 SA Payload Same as the Common Packet #13 Ni, Nr Payload Other fields are same as the common packet #13 Payload Length 4 Nonce Data empty TSi Payload Same as the Common Packet #13 TSr Payload Same as the Common Packet #13
Part A: (BASIC) 1. TN1 starts to negotiate with NUT by sending IKE_SA_INIT request. 2. Observe the messages transmitted on Link A. 3. After a reception of IKE_SA_INIT response from the NUT, TN1 transmits IKE_AUTH request to the NUT. 4. Observe the messages transmitted on Link A. 5. After reception of IKE_AUTH response from the NUT, TN1 transmits CREATE_CHILD_SA request which has no data as Nonce Data as Ni payload. 6. Observe the messages transmitted on Link A.
Part A Step 2: Judgment #1 The NUT transmits an IKE_SA_INIT response including "ENCR_3DES", "PRF_HMAC_SHA1", "AUTH_HMAC_SHA1_96" and "D-H group 2" as accepted algorithms. Step 4: Judgment #2 The NUT transmits an IKE_AUTH response including "ENCR_3DES", "AUTH_HMAC_SHA1_96" and "No Extended Sequence Numbers" as accepted algorithms. Step 6: Judgment #3 The NUT does not transmits a CREATE_CHILD_SA response or transmits a CREATE_CHILD_SA response including a Notify payload of type INVALID_SYNTAX.
* None.