The best environmental temperature for charging is between 5 °C to 35 °C. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time.

Shaver display The shaver display (14) shows the charge status of the battery. During charging or when using the shaver, the respective battery segment will blink (green). When fully charged, all segments will light up for approximately one hour, provided the shaver sits in the C&R station.

The red low-charge light flashes when the battery is running low. You should be able to finish your shave.

B Shaving Press the on/off switch (13) to operate the shaver.

Comfort setting switch «sensitive» Setting the shaver head according to your comfort needs.

The «sensitive» switch (11) provides three options for comfort setting:

1 « + » : The shaver head is in full swing, freely follows the contours of your skin to provide more comfort.

2 middle position: The shaver head is semi-fixed for more control.

3 « – » : The shaver head is fixed for full control and precise handling in hard to reach areas.

Long hair trimmer To trim sideburns, moustache or beard, slide the long hair trimmer (10) upwards.

Tips for the perfect shave For best results, Braun recommends you follow 3 simple steps: 1. Always shave before washing your face. 2. At all times, hold the shaver at right

angles (90°) to your skin. 3. Stretch your skin and shave against the

direction of your beard growth.

Shaving with the cord If the shaver has run out of power (discharged), you may also shave with the shaver connected to an electrical outlet via the special cord set.

Cleaning For best shaving results, we recommend cleaning the shaver in the station after each shave (see «Automatic cleaning»). All charging and cleaning needs are then automatically taken care of.

Cleaning indicator Clean your shaver in the Clean&Renew station at the latest when the yellow cleaning light (15) shines constantly after shaving. If this is not done, the cleaning light will go off after some time and the counter will be reset.

C Automatic cleaning The Clean&Renew has been developed for cleaning, charging and storing your shaver. After each shave, return the shaver to the Clean&Renew station and proceed as follows:

Insert the shaver head down into the cleaning station. Push down the start button (4). The clean- ing process will start (approx. 5 minutes cleaning, 4 hours drying). Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use.

•

99265630_590cc_S6-64.indd 7 26.05.2009 11:00:14 Uhr